Declaration Of Ce Conformity - Conrad ReFLEX 200 multi Bedienungsanleitung

GB
Operating instructions
ReFLEX 200 multi
Item No.: 250199
Important
Please read these operating instructions carefully! In the event of any
damage caused by the failure to observe the operating instructions, the
warranty claim shall cease to exist. The manufacturer does not accept any
liability for consequential damages.
Correct use of this charger
This charger serves the sole purpose of charging NiCd (nickel-cadmium) and
NiMH (nickel-metal-hydride) accumulator packs that have been designed for
boost charge and that consist of at least 4 and at most 16 cells connected in
series. The exception are accumulator packs consisting of 13 cells which are not
supported due to the limited number of switch positions. The cell capacity must be
between approx. 200mAh and a maximum of 8000mAh, which is equivalent to
manufactured sizes from R1 DIN 40861 (lady) to R20 DIN 40866 (mono). 9V
compound (block) accumulators usually contain 7 to 8 mass cells, which are not
designed for boost charge, and consequently they should not be charged with this
device.
The use of switched-power technology enables the adjustment of the charging
current from 0.2 to 8A for all selectable numbers of cells.
Please refer to chapter 2 (Safety remarks) for further details on the correct use of
this device.

Declaration of CE conformity:

With sole responsibility, the manufacturer declares that this product corresponds
to the following standards:
ES 50081-1, ES 50082-1, ES 60335, ES 61000-3-2, ES 61000-3-3 in accordance
with the rules of the directives: 73/23/EEC and 89/336/EEC
For you, the user, this means that you have purchased a product that, in terms of
design, fulfils the objectives of the European Community for the safe and trouble-
free operation of the appliance.
! These instructions must be read carefully!
3