Rollei 5S Anleitung Seite 13

You can set the resolution to any of the following three modes:
8M, with an image resolution of 3200 x 2400.
12M, with an image resolution of 3840 x 2880.
16M, with an image resolution of 4608 x 3456 (interpolated).
Four photo shooting modes are available for the video camera.
a. single shot (the default mode)
In the preview state, press the "Photo" key once to take a picture while the system generates a
click tone. The green indicator on the front side of the video camera also blinks once (the shooting
icon on the LCD segment screen blinks once), and the video camera restores to the preview state.
b. Fast shot
On the camera setup interface, press the "+" or "–" key and choose "Fast shot". Press "OK" to
display the interface. Press the ">" key, and choose 3 p/s or 6p/s or 10 p/s (photo/second).
Press "OK" again to exit the interface. Press the "M" key to exit the camera setup interface. After
setting is complete, the Rollei 5S video camera continuously takes three pictures or six pictures or
ten pictures when you press the Photo key once.
c. Auto cont capture
On the camera setup interface, press the "–" key and choose "Auto Cont Capture". Press "OK"
to set the time interval for continuous shooting to OFF, 0.5s,1s, 2s, 3s, 5s, 10s, 20s ,30s or 60s .
After press the ">" key to set the time interval. Press "OK" again to exit the intreface. Press the "M"
key to exit the setup interface. At this time, if you press the "Photo" key, the Rollei 5S video
camera takes a picture at each interval until you press the "Stop" key to cancel shooting.
d. Timed shooting: On the camera setup interface, press the "+" key and choose "Timed Shooting".
Press "OK" to set the time in auto-shooting mode to OFF, 3 s, 5 s, or 10 s. Press the ">" key, and
choose "Timed Shooting". Press "OK" again to save and exit the interface. Press the M key to
exit the camera setup interface. After setting is complete, the Rollei 5S video camera starts
reverse-counting timer when you press the Photo key once. When the preset time is reached, the
Rollei 5S video camera takes a picture.
5. Recording an Audio File
To record an audio file, perform the following operations:
— Press the "M" key on the video camera setup interface, choose " Exe", and then press "OK" to
display the video and audio options.
— Press the "<" or ">" key, and choose "
ready for audio recording.
— Press the "Video" key to start recording an audio file. At this time, the green indicator blinks
slowly. The video camera also displays the audio recording symbol on the TFT screen and starts
counting time. In addition, the recording duration is correctly displayed on the LCD segment
screen.
— Press the "Stop" key to save and stop the currently recorded audio file. At this time, the green
indicator on the front side is off. The video camera restores to the preview state for audio
recording. The recording duration also disappears on the LCD segment
After audio recording is complete, press the "M" key. On the system setup interface, choose
"Exe", press "OK" to display the video and audio options, and choose "Video". Press "OK" again
to exit the setup interface. The video camera restores to the preview state for video recording.
Note:
a. Power on the video camera again to restore to the video recording mode. After audio recording is
complete, you can also press the "
b. Press and hold the Stop key for two seconds to directly change the video camera to the ready state
for audio only.
" for audio only, and press "OK" again. The system gets
" key twice to restore to the video recording mode.
-11-
screen.
EN