Rollei 5S Anleitung Seite 8

G TF card capacity indication: The "
corner, indicating the available space of the TF card. The more bars the power indicator has, the
EN
more free space you have. If the TF card is full, the green indicator on the left side is constantly on.
At this time, on the TFT screen, you can find the following information:
A Working mode: The "
that the video camera is ready for video recording.
B Battery capacity: The "
the battery level.
C Video resolution: The resolution icon in the bottom-left corner indicates the current video
recording resolution.
D Available storage capacity: If a memory card is available upon power-on of the video camera, the
" " (free space of the memory card) icon is displayed in the bottom-right corner.
E There is no response for "<" and ">" keys in the preview state.
F When using the supplied USB cable to recharge the battery in power off , the "Working/recharging
red indicator" on the top of the video camera blinks slowly. The red indicator will be constantly on
upon full recharging. The recharging time lasts for about three hours.
Note:
a. Before using the video camera, check whether the battery has sufficient power. If the power level
is low, use the USB cable supplied with the video camera to recharge the battery. The " Working /
recharging red indicator " blinks slowly during the recharging. Upon full recharging, the red
indicator is constantly on, and the "
b. Except USB cable, it is ok to recharge the battery with any 5V/2A power adapter.
② Formatting the Micro SD card
The Micro SD card must be a high-speed card. Before video/audio recording and shooting pictures,
format the Micro SD card on the Rollei 5S video camera. If a Micro SD card has been used on other
devices, it should also be formatted on the Rollei 5S video camera for normal use.
Note:
Before formatting, make sure the files in the memory and Micro SD card are not needed. Even the
locked files on the video camera can be removed in formatting.
③ Setting the data and time
To set the date and time, perform the following operations:
− In the preview mode under power-on state, press the "M" key to display the menu interface.
− Press ">" to enter the "
− Press "+"or "–" to display the "01/01/2013 00:00" menu.
− Press "OK" to display the "Date / Time" interface shown as follows.
Date / Time
" (TF card capacity) icon is displayed in the bottom-right
" (Video recording) symbol is displayed in the upper-left corner, indicating
"(battery power) symbol is displayed in the upper-left corner, indicating
" (battery power) symbol is displayed on the TFT screen.
" system setup interface.
The digits under the cursor will turn blue and adjustable:
− Press "+" or "–" to adjust the date or time.
− Press "OK" after adjusting the date or time.
− Press the "M" key to exit the interface.
-6-