Operations - Rollei 5S Anleitung

1. Insert a Micro SD card into the Rollei 5S video camera
Note: Use a branded Micro SD card. We recommend Class 10 memory cards.
EN
2. Powering on the Rollei 5S Video camera
Turn the power switch to the ON position to power on the Rollei 5S video camera. At this time,
the red indicator is on, and the Rollei 5S video camera changes to the preview state.
Note:
a. If the battery power is low, the " " symbol is displayed on the TFT screen together with a promot.
b. If no Micro SD card is inserted, no symbol is displayed in the bottom-right corner of the TFT screen.
3. Recording a Video
In the preview state, press the "Video" key to start video recording. The video recording duration
is displayed in the upper-right part of the TFT screen. The "Video/Audio indicator (green)" and the
"Video/Photo indicator (green)" on the top of the video camera blink slowly. The recording
duration is correctly displayed on the LCD segment screen. During video recording, the video
camera responds only to operations for the zoom out (–) and zoom in (+) keys. Press the "Stop"
key once to stop and save the currently recorded video file, and the video indicator (green) on the
front side is off. The video camera restores to the preview state. The recording duration disappears
on the LCD segment screen.
Note:
a. During video recording, turn the power switch to the "OFF" position to power off the video
camera after saving the currently recorded file.
b. During video recording, if the battery power runs low, the system saves the currently recorded file
and enters standby mode, displaying a prompt of "Low battery " on the TFT screen, until the video
camera is powered off.
c. During video recording, if the Micro SD card is full, the system saves the currently recorded file.
The system also displays a message "Card full" on the TFT screen, indicating that the Micro SD card
is full. In addition, the duration for video recording stops on the LCD segment screen, and the
system restores to the preview state.
d. Synchro Shot function: during the recording process,press the Shutter Key , the camera will take a
picture without interruption.（The synchro Shot function is unavailable in 1080i, 960P/48f,
960P/50f, 480P/100f and 480P/120f mode）
e. In Loop recording mode, the system automatically saves a file every 15 minutes. (The cyclic
recording function and the pre-video function cannot be simultaneously enabled.)
f. If the D23 backup battery is provided and fully recharged, the video camera can continuously
record video programs for about 160 minutes and record audio programs for about 180 minutes.
g. In 480P/100f and 480P/120f modes, the video camera does not support the zooming.
h. In audio recording mode, the volume cannot be adjusted by pressing the "+" or "–" key. In
playback, however, the volume can adjusted by pressing the "+" or "–" key.
i. If the video camera provides a TFT screen and is in the preview state, after using a HDMI patch cord
to connect the video camera to a HD display device, you can perform basic operations for the video
camera on the HD display device (These basic operations, however, cannot be performed if no TFT
screen is available on the video camera).
4. Taking a Picture
Before taking a picture, perform the following operations to set the image resolution.
— Press the "M" key to display the setup interface.
— Press the ">" key to display the camera setup interface (
— Press the "+" or "–" key and choose "Image Resolution".
OK
— Press " " to display the resolution setup menu.
).
-10-

Operations