Parameter Settings - Rollei 5S Anleitung

Parameter Settings

To set parameters, perform the following operations:
− In the preview mode under power-on state, press the "M" key to display the menu interface.
− Press the "<" or ">" key to choose a left or right option from the menu interface.
− Press the "+" or "–" key to choose an upper or lower option from the menu interface.
− After selecting an option, press "OK" to save settings.
− Press the "M" key again to save the setting and exit the interface.
Note:
After power-on, the video camera adopts all the preset settings, except for audio recording mode. You
can change settings as you desire.
① Set video camera parameters
a. Exe.: Select " "(the default mode) for video recording and "
b. Resolution for video recording: Select the desired resolution for video recording. You can set this
parameter to the 1080P, 1080i, 960P, 720P or 480P resolution.
For the
PAL
1920x1080P 25f 1920x1080I 50f
system
16:9
For the
NTSC
1920x1080P 30f 1920x1080I 60f
system
16:9
c. : This parameter involves three types of views: Wide Angle (
Angle
Narrow Angle (
The following example shows the same picture in different views:
Wide Angle
Middle Angle
Narrow Angle
The preceding views apply only to the 1080P or 1080i HD video recording and photo modes.
You can select a view angle as you desire.
d. Bit rate: This parameter can be set to High bit rate (
to High, pictures are clearer, but the file size increases.
e. Laser SYNC video: Select "
disable the laser indicator.
If this parameter is set to "
off automatically in 20 seconds.
f. Pre-video: In the preview state, press the "M" key to enter the video recording setup interface,
choose "Pre-video" to enable the pre-video recording function.
In this mode, press the "Video" key to enable the pre-recording function, that is the video
recording starts without saving the data; press the Video key again, the last a few seconds of the
pre-recorded video will be saved as the starting part of the video recording file.
g. Auto video: In the preview state, press the "M" key to enter the video recording setup interface,
choose "Auto video", and set the count-down time before the automatic video recording. The
available options are "OFF, 5 s, 10 s, or 20s".
h. Display time: In the preview state, press the "M" key to enter the video recording setup interface,
choose "DISPLAY TIME".
1280x960P 25f 1280x960P 50f
16:9 4:3
1280x960P 30f 1280x960P 48f
16:9 4:3
).
Comparison of the same scenery in different view angles
Wide Angle
" to enable the laser indicator, or select "
",the laser will be turned on when starting recording and be turned
1280x720P 50f 1280x720P 25f
4:3 16:9 16:9
1280x720P 60f 1280x720P 30f
4:3 16:9 16:9
Middle Angle
) or Normal (
-7-
" for audio only.
848x480P 100f 848x480P 50f
16:9 16:9
848x480P 120f 848x480P 60f
16:9 16:9
), Middle Angle (
Narrow Angle
). If this parameter is set
" (the default option) to
EN
), and