C) Resetting The Speed Controller - Reely Micro Carbon Fighter Bedienungsanleitung

• Function #5, green LED, flashes 5x short: Maximum braking strength
The speed controller unit allows proportional braking strength depending on the setting of the transmitter lever. The
maximum braking power at full lever extension can be adjusted to 25%, 50%, 75% and 100%.
A high setting (e.g. 100%) decreases braking distance but has a negative effect on the lifetime of the gears (drive
pinion gear, main gear and differential gears).

c) Resetting the Speed Controller

This function will reset all settings that were adjusted when setting up the speed controller unit can be returned to the
original factory settings.
Proceed as follows:
• Switch on the transmitter. Leave the throttle/brake lever in its neutral position and do not move it.
• Switch on the speed controller (move the slider towards the setup button). The vehicle should now be ready for
operation; no LED is lit on the speed controller.
• Press and hold the setup button until the red and green LEDs flash slowly at the same time.
• The two LEDs go out after a few seconds.
• Now switch off the speed controller (Move the slider away from the setup button). All settings are now reset to the
factory setting, see table in chapter 10 b).
The programming of the neutral position and the full throttle positions for forward and reverse driving are deleted as
well.
For reprogramming of the speed controller, observe chapter 10. a) and 10. b).
Important!
If a LiPo battery is used as a drive battery, check the basic settings of the speed controller for whether
undervoltage protection is activated (usually 3.0 V/cell). With the undervoltage recognition deactivated, the
LiPo battery will suffer deep discharge and be destroyed.
If an NiMH--drive battery is used, deactivate the undervoltage recognition.
44