O) Setting The Flight Control System - Reely Christen Eagle Bedienungsanleitung

o) Setting the Flight Control System

The flight controller (1) has a 2 pin cable with a connector attached (2) to
which a short-circuit plug (3) is attached.
To better illustrate the controller, it has been shown removed
from the model.
Practical tips:
Self-adhesive velcro has proven to be ideal for affixing the flight controller.
The fluffy part is glued to the controller.
Using the short-circuit plug, you can now determine at which voltage the
controller should switch off the motor, in order to avoid excessive
discharging of the rechargeable flight battery.
If the sort-circuit plug is attached the cut-out voltage is 5 V. This setting is to be used with a 2 cell LiPo rechargeable flight battery.
If the sort-circuit plug is not attached the cut-out voltage is 7.5 V. This setting is to be used with a 3 cell LiPo rechargeable flight battery.
Attention important!
As the model is powered by a 3 cell rechargeable battery, the short-circuit plug must be removed.
Then cut a small piece of foam from the model packaging and stick it over the connector pins. Now wrap the whole thing with some adhesive tape, this is perfect
protection for the pins and against any short-circuit.
Further settings options are not foreseen for the flight controller.
48
Figure 17