Working With The Electric Hedge Trimmer; Cutting Techniques - FLORABEST FHT 600 B2 Betriebsanleitung

GB
Ensure that the trimmer is in contact
with no other objects before switch-
ing on.
In this way you avoid damage to
the appliance and possible injury to
people.
1. For tension relief of the cable,
form a loop of the end of the
extension cable and bring this
through the opening at the han-
dle and suspend in the tension
relief at the grip (7).
2. Connect the device to the mains
voltage.
3. Hold the safety switch on the loop
handle (4) and push the On/
Off switch on the grip (6) at the
same time to switch the unit on.
The hedge trimmer will be run at
maximum speed.
4. Release one of the two switches to
switch the trimmer off.
Working with the Electric
Hedge Trimmer
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage to
the cutter bar.
• Switch off the equipment immediately
in the event that the blades are blocked
by solid objects, pull out the power plug
then remove the object.
• Always work away from the mains pow-
er outlet. Set the cutting direction before
starting work. Ensure that the power
cable is kept well away from the work-
ing area. Never lay the cable over the
hedge, where it could easily be caught
up in the trimmer blades.
34
• Avoid overstraining the equipment dur-
ing work.
Pull out the power plug im-
mediately if the cable is dam-
aged, badly twisted or has
been completely cut through.

Cutting Techniques

• Cut thick branches beforehand using a
branch clippers.
• The double-sided cutter bar enables cut-
ting in both directions or, with a swinging
action, from one side to the other.
• In case of vertical cutting, move the
hedge trimmer uniformly forward or up
and down in an arc movement.
• In case of horizontal cutting, move the
hedge trimmer in a sickle-shaped move-
ment to the edge of the hedge, so that
cut branches fall to the ground.
• In order to achieve long straight lines,
the placing of tensioned guiding cords is
recommended.
Cutting Shaped Hedges:
It is recommended that hedges be cut in
a trapezoidal shape, in order to prevent
stripping off of the lower branches. This cor-
responds to the natural plant growth and
allows the hedge to thrive optimally. During
cutting, only the new annual growths are
reduced and thus a dense branching and a
good screen will develop.
1. Cut the sides of a hedge first. To
do this, move the hedge trimmer
in the direction of growth from
bottom to top. If you cut down
from the top, the thinner branches
will move out, which may result in
some areas having sparse growth
or holes.