Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following information.
Customer service will charge you for advice, even if the appliance is still under guarantee!
Fault
Temperature differs
greatly from the set
value.
Interior light does not
function.
function.
Floor of the refrigerator
compartment is wet.
The refrigerating unit
is switching on more
is switching on more
frequently and for
longer.
Temperature display
light 2c flashes.
(The freezer compart
(The freezer compart
ment is too warm)
No temperature display
lamp comes on.
lamp comes on.
28
Possible cause
The bulb is defective.
Light switch (A) is sticking.
The condensation outlet
is blocked.
Appliance door opened frequently.
The ventilation openings have
been covered.
Appliance door opened frequently.
A lot of food was placed in the
freezer.
The ventilation openings have
been covered.
Appliance has been switched off.
Power failure; the fuse has been
switched off; the mains plug has
not been inserted properly.
Remedial action
In some cases it is adequate to switch off the
appliance for 5 minutes.
If the temperature is too high wait a few hours and
check whether the temperature has approached the
set value.
If the temperature is too low check the temperature
again the next day.
Replace bulb (B)
1. Pull out the mains plug or disconnect the fuse.
2. Remove bulb cover towards the rear.
3. Change the bulb
3. Change the bulb
(replacement bulb, 220 240 V a.c.,
E14 lampholder, see defective bulb for wattage).
Check whether it can be moved.
Clean the condensation channel and the outlet
(see Cleaning the appliance)
Do not open the door unnecessarily.
Remove obstacles.
Do not open the door unnecessarily.
Switch on Super cooling before placing food in the
freezer.
Remove obstacles.
Press the On/Off button 2a.
Check whether the power is on,
Check the fuses.