Commissioning/Start-Up; Protective Measures; Order Of Starting Up Steps - Oase ProfiClear Premium Compact Gebrauchsanweisung

5.

Commissioning/start-up

Thoroughly clean the pond before starting up the filter system for the first time to ensure that it is not
►
overloaded by excessively soiled water. OASE recommends using the PondoVac pond vacuum
cleaner for cleaning the pond.
This cleaning measure is normally not necessary for newly installed ponds.

It is necessary to operate the filter system for 24 hours a day during the pond season.
►
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures: Isolate the unit prior to reaching into the water and carrying out any work on the
unit. Secure the unit from being switched on inadvertantly.
Attention! Sensitive electrical components.
Possible consequence: The unit will be destroyed.
Protective measure:
Do not connect the unit to a dimmable power supply.
►
Do not operate the unit with a timer.
►
Attention! Never allow the rinsing pump to run dry!
Possible consequences: The rinsing pump will be destroyed.

Protective measures:

Check the water level at regular intervals. Ensure that the rinsing pump is always under water during
►
operation.
Do not switch on the control system until the container is flooded with water.
►
5.1

Order of starting up steps

Pump fed system
 H
How to proceed:
1. Close the slide valve for the dirt outlet at the bottom of the container.
2. Check that the entire filter system (pipes and hoses) is complete.
3. Remove the container cover.
The filter drum is stopped for safety reasons if the filter cover is lifted and Er11 is indicated in the

display of the control system.
Moving bed filter chamber
The moving bed filter chamber contains two 20 l sacks of Hel-X 13 biomedia (40 l). Optionally, 60 l can be
used (supplementary kit Order No.: 42904).
4. Tip the Hel-X biomedia from the bags into the moving bed filter chamber.
Ensure that the Hel-X biomedia can move around freely in the container.

It can take several weeks for the Hel-X biomedia to become completely colonised. Uncolonised Hex-

X biomedia tend to float more.
When using the supplementary kit, add the biomedia gradually. We recommend adding max. 5 l per
week.
2222555555
- EN -
49