Installation And Connection; Commissioning/Start-Up; Switching On/Off - Oase AquaOxy 2500 Inbetriebnahme

Installation and connection

WARNING
The unit carries hazardous electric voltage and must not be installed immediately adjacent to
water. Otherwise, there is a risk of injuries or death by electrocution.
Install the the unit in a flood-protected position at a distance of at least 6.6 ft (2 m) from the

water.
NOTE
 Make sure that no water is flowing into the unit through the hoses as this can damage the
unit.
 If the unit is switched off at intervals (e.g. via a timer) for several hours at a time, condensate
can form on the inside of the unit, which can damage it. For interval operation, therefore, only
install the unit in an enclosed space at room temperature.
 The metal components inside the unit may corrode at high humidity levels. This is a normal
occurrence and not a basis for a claim within the framework of the guarantee or warranty.
How to proceed:
 A
• Install the unit horizontally on a firm, mud-free surface. Ensure that the unit is securely posi-
tioned.
• Do not place the unit in direct sunlight as this can cause it to heat up significantly. Use a pro-
tective cover if necessary.
• The air inlet gap around the perimeter of the lid must not be covered over.
• Position the aerator element (accessory) in the desired positions inside the pond.
• Lay the air hose so that it is protected from damage and nobody can trip over it.
• Keep air hoses as short as possible to optimize the aeration effect.

Commissioning/start-up

Switching ON/OFF

• Switching on: Plug the power plug into the outlet.
– The unit switches on immediately.
• Switching off: Pull the power plug from the outlet.
10