Submerged Installation Of The Unit; Dry Installation Of The Unit; Commissioning/Start-Up; Switching On/Off - Oase AquaMax Eco Classic 2500E Inbetriebnahme

Submerged installation of the unit

Connection
 B
Do not plug the power plug into the outlet yet!
Installation
 C
• Position the pump horizontally on a firm, mud-free surface.
• Ensure that the pump is securely positioned.
• Only operate the pump when it is fully submerged.

A pull rope allows you to simply pull the pump out of the water.
− Pull the pull rope through the round openings on the bottom pan of the filter and make a
knot.

Dry installation of the unit


For information, please refer to the operating manual.

Commissioning/start-up

NOTE
Never connect the pump to a dimmer. This will destroy the pump
NOTE
Never allow the pump to run dry. Otherwise the pump will be destroyed.
 Only operate the pump when it is submerged or flooded.

Switching ON/OFF

• Switching on: Plug the power plug into the outlet.
– The unit switches on immediately.
• Switching off: Pull the power plug from the outlet.

Environmental Function Control (EFC)

When started up, the pump automatically performs a pre-programmed self-test (Environmental
Function Control (EFC)). The pump detects if it is running dry / blocked or submerged. The pump
turns off automatically after 60 to 120 seconds if it runs dry/is blocked. In the event of a mal-
function, disconnect the power supply and "flood the pump" or remove the obstacle. Afterwards,
the unit can be restarted.
12