Connecting And Installing The Control System; Connecting An External Aerator Pump - Oase ProfiClear Premium Compact Gebrauchsanweisung

- EN -
4.3

Connecting and installing the control system

The cable harness contains the connection cables of the signal box, the drum motor and the rinsing pump.
Connecting
 N
Connect the three connectors of the cable harness to the control system sockets. Hand-tighten the
►
union nuts.
The connections are designed to prevent misconnection.

First flood the container with water, then connect the control system to the mains voltage/power

supply.
Installation: Pump fed system
Install the control system at least 2 m away from the pond.
►
Protect the control system from direct sunlight.
►
The control system is splash-proof and may be exposed to rain.
►
Suspended installation of the control system: Either on the mount on the container wall of the Drum
►
Filter Module or using the threaded hooks in another position.
Installation: Gravity fed system
 D
Install the control system at least 2 m away from the pond.
►
Protect the control system from direct sunlight.
►
The control system is splash-proof and may be exposed to rain.
►
Push both ground stakes onto the control system and push the ground stakes into the ground.
►
If the ground is hard:
Protect the control system from knocks/impact.
►
Push both ground stakes onto the control system.
►
With light pressure push the ground stakes into the ground to mark the position.
►
Detach the ground stakes from the control system and drive them into the ground.
►
Then push the control system onto the stakes.
►
4.4

Connecting an external aerator pump

Connect the aerator rods in the container to an external aerator pump.
►
OASE recommends: OASE AquaOxy 2000 pond aerator.
How to proceed:
 P
1. Connect the hose from the external aerator pump to the air connection and fit the air connection onto
the container.
For thinner  4 mm air hoses, use the 4/9 mm adapter and secure the connection with a cable

binder if necessary.
Ensure that the aeration is not too high during the filter start-up phase. Excessive turbulence delays the
initial colonisation of micro-organisms. We recommend approx. 1000 l/h.
48