Install The Receiver; Commissioning/Start-Up; Switching On/Off; Environmental Function Control (Efc) - Oase AquaMax Eco Twin 20000 Inbetriebnahme

Install the receiver

NOTE
The receiver will be damaged if it is constantly subjected to moisture.
 Install the receiver in a moisture-protected location.
 If necessary, use a protective cover.
 E
• Position the receiver in a flood-protected location at least 2 m from the edge of the pond.
• Fasten it to the ground with the ground stake or suspend it vertically using 2 screws.
– Do not operate the receiver while it is in a horizontal position, only operate it in a vertical
position with the ground stake intake pointing down.
Do not plug the power plug into the socket yet!

Commissioning/start-up

NOTE
The unit will be destroyed if it is operated with a dimmer. It contains sensitive electrical compo-
nents.
 Do not connect the unit to a dimmable power supply.
NOTE
Prevent the pump from running dry. Otherwise the pump will be destroyed.
 Only operate the pump when it is submerged or flooded.

Switching ON/OFF

• Switching on: Plug the power plug into the outlet.
– The unit switches on immediately.
• Switching off: Pull the power plug from the outlet.

Environmental Function Control (EFC)

When started up, the pump automatically performs a pre-programmed self-test (Environmental
Function Control (EFC)). The pump detects if it is running dry / blocked or submerged. The pump
shuts down automatically after 60 to 120 seconds if it runs dry/is blocked. In the event of a mal-
function, disconnect the power supply and "flood the pump" or remove the obstacle. Afterwards,
the unit can be restarted.
EN
17