Troubleshooting - Silvercrest SSTB 10 A1 Bedienungsanleitung Und Sicherheitshinweise

NOTE
► The next time you turn on the device it will automatically connect to the last
Bluetooth
device does not automatically reconnect to the device, you will have to
re-establish the connection to your Bluetooth
ally. A detailed description of how to do this can be found in the operating
instructions for your Bluetooth
► If you use a smartphone as your Bluetooth
playback will be paused when there is an incoming call. Acceptance/termi-
nation of the call is carried out via the smartphone. After finishing the call,
the playback will be automatically continued.
► You can use keys
device and on the remote control to operate the basic functions when play-
ing music in Bluetooth
► Note that while in Bluetooth
Bluetooth
► If the playback sounds distorted, reduce the volume on the Bluetooth
playback device.
► It is possible that no all functions will be supported depending on the
Bluetooth

Troubleshooting

This section contains important information on fault identification and rectification. The fol-
lowing table will help to identify and rectify minor faults:
Fault
The device will not
switch on.
No sound.
SSTB 10 A1
playback device connected. If your Bluetooth
®
( + ),
operating mode.
®
®
playback device.
®
player and operating system being used.
®
Possible cause
The mains adapter is
not connected.
The socket is not supply-
ing any power.
The volume on the device
or the playback device is
set to minimum.
Playback has not been
started on the playback
device.
You have selected the
incorrect operating
mode.
playback device manu-
®
playback device.
®
playback device, the audio
®
( + ) and
mode, you can also set the volume via the
Remedy
Connect the mains adapter correctly.
Check the house's mains fuse.
Increase the volume on the device or
on the playback device.
Start playback on the playback
device.
Check whether the correct operating
mode (AUX or Bluetooth
been set.
playback
®
( + ) on the
®
) has
®
│ 13 ■
GB