Charging Mobile Devices With The Speaker; Troubleshooting - Silvercrest SLXL 20 A1 Kurzanleitung

Charging mobile devices with the speaker

♦ Connect the micro-USB plug on the charger cable
charging port on the mobile device to be charged.
♦ Connect the USB type A connector on the charger cable
A socket
♦ Switch on the speaker. The charging process begins automatically.
♦ If charging does not start automatically, press the
the charging process.
NOTE
► Alternatively, you can also use the original charging cable (USB cable)
provided by the respective device manufacturer.
♦ During charging, the current charge level of the speaker is shown via the
charge level LEDs
♦ To stop charging, disconnect the charging cable from the mobile device and
the speaker.

Troubleshooting

The speaker cannot be paired with a compatible Bluetooth
device
Make sure that the Bluetooth
♦
device. When a device is connected via a 3.5 mm jack cable
Bluetooth
♦ Make sure that the speaker is switched on.
If you use several Bluetooth
♦
is disconnected. There may be a previously paired Bluetooth
range.
Make sure that the speaker is no more than 10 metres from the Bluetooth
♦
device and that no obstacles or electronic devices are placed between them.
You cannot switch on the speaker
♦ The integrated battery in the speaker is empty. Recharge the battery.
You cannot use all of the described functions
This may be down to your Bluetooth
♦
Try updating the software or using a different Bluetooth
SLXL 20 A1
on the speaker.
(see table in the section Checking the charge level).
®
®
function is deactivated.
®
devices, ensure that any previous connection
to the micro-USB
button
function is activated on the Bluetooth
®
device and its current software.
to the USB type
briefly to start
®
®
, the
®
device in
®
®
device.
GB │ IE │ NI │
15 ■