Troubleshooting Table - hanseatic AC925EC3-S00E Gebrauchsanleitung

Page GB-26

Troubleshooting table

Troubleshooting table
Malfunctions can occur in all electrical appliances. This does not necessarily mean there is a
defect in the appliance. For this reason, please check the tables to see if you can correct the
malfunction.
WARNING
Risk of electric shock!
Never try to repair a defective or suspected defective appliance yourself. In case of
improper repairs, you may endanger yourself and others using the appliance later.
Only authorised specialists are allowed to carry out these repairs.
Problem Possible cause
Display is not No electricity to socket.
working, appli-
ance does not
Mains plug is loose.
operate.
The door cannot Foreign bodies on the door
be closed prop- seal faces.
erly.
The cooking chamber's
door is broken or the door
lock is defective.
The cooking Lamp defective.
chamber's light
does not work.
Cooking chamber In microwave operation with
light is dimmed. low power, it is possible that
the cooking chamber light-
ing is reduced.
The rotary plate The rotary plate is not cor-
does not turn, rectly positioned on the
or does not turn drive motor.
properly.
The cooking chamber floor
is dirty.
Scratching, grind- The food dish is either too
ing sounds in the large or is positioned incor-
cooking chamber. rectly.
Exploding, pop- The dish is being cooked
ping sounds in the and/or defrosted with too
cooking chamber. much power, and will burst
open.
Other noises or Sparks – metal objects in
flashes of light the cooking chamber!
in the cooking
chamber.
The dish is The dish was not sufficiently
cooked unevenly. rotated or stirred.
Solutions, tips
Check the socket by connecting another
appliance.
Check the tightness of the mains plug.
Clean the door seal faces thoroughly.
Have the door repaired.
Do not use the device!
Contact customer service (see „Service"
on page GB-28).
No error.
Position the rotary plate correctly.
Clean the cooking chamber floor thoroughly.
The container may not protrude over the
edge of the rotary plate.
Cancel the setting and reselect a lower
power level. Pierce or cut into the food if
necessary.
Switch off the device immediately and then
remove any metallic objects.
Stir or rotate the food dish, and allow it to
heat up a little more.