Troubleshooting Table - hanseatic D70H20L-DB Gebrauchsanleitung

Troubleshooting table

Malfunctions can occur in all electrical appliances. This does not necessarily mean there is a
defect in the appliance. For this reason, please check the tables to see if you can correct the
malfunction.
WARNING
Risk of electric shock in case of improper repair!
Never try to repair a defective or suspected defective appliance yourself. You can put
your own and future users' lives in danger. Only authorised specialists are allowed to
carry out this repair work.
Problem Possible cause
Device will not No electricity to socket.
start.
Mains plug is loose.
Door will not close Foreign bodies on the door
properly. sealing surfaces.
Door damaged or door lock
defective.
Cooking chamber Lamp defective.
lighting does not
work.
The rotary plate The rotary plate is not correctly
does not turn, positioned on the drive motor.
or does not turn The cooking chamber floor is
properly. dirty.
Scratching, drag- The rotary plate does not turn
ging noises in the correctly.
cooking compart-
The food dish is either too large
ment. or is positioned incorrectly.
Exploding, pop- The dish is being cooked and/
ping noises in the or defrosted with too much
cooking compart- power, and will burst open.
ment.
Other noises or Sparks are produced - metal in
flashes in the the cooking compartment!
cooking compart-
ment.
The dish is The dish was not sufficiently
cooked unevenly. rotated or stirred.
The dish does not Power or time is set too low.
heat up enough.
The dish was very cold when
being placed inside.
Container is unsuitable if it be-
comes hotter than the dish.
Door and/or The dish releases moisture.
viewing window
steams up.
Troubleshooting table
Solutions, tips
Check by connecting another appli-
ance.
Check that the mains plug is fitted se-
curely.
Clean the door sealing surfaces thor-
oughly.
Have the door repaired.
Do not use the appliance!
Contact our service team (see „Ser-
vice" on page GB-22).
Insert the rotary plate correctly.
Clean the cooking compartment floor
thoroughly.
Insert the rotary plate correctly
The container may not protrude over
the edge of the rotary plate.
Cancel the setting and reselect a lower
power level.
Switch off the device immediately and
then remove any metallic objects.
Stir or rotate the food dish, and allow it
to heat up a little more.
Keep warming up the food for a short
while in the microwave.
Use a suitable container.
No error. Simply wipe away any mois-
ture after operation.
Page GB-21