Installation; Operation; Working With The Equipment - FLORABEST FSG 85 B1 Betriebsanleitung

GB

Installation

Always use the M10x70 screws
from the package to mount the unit.
. Make.sure.to.leave.enough.
room.for.working.and.that.
nobody.else.is.put.at.risk.
. Always.use.screws.of.suf-
ficient.length.and.thickness.
to.mount.the.device.on.the.
work.surface,.in.order.to.
prevent.loss.of.control.of.the.
device.
Installing.the.appliance:
- Thickness of the table edge:
15 - 30 mm.
- Drill diameter: 10.5 mm.
- Size of screw: M10
1. Use the stop notches (9) to cor-
rectly place the appliance on the
worktop (22). Make sure that the
grinding plinth (8) protrudes be-
yond the edge of the table.
2. Use a pen to mark the drill holes
and remove the appliance.
3. Drill two holes into the worktop
(22).
4. Use the screws (23) and nuts (24)
from the package to attach the
grinding plinth to the worktop.
Assembling.the.grinder:
5. Screw the handle (4) into the
grinding head (2).
6. Remove the locking screw (10)
from the chain clamping unit (12).
7. Place the chain clamping unit
(12) on the grinding plinth (8)
38
and fix it using the locking screw
(10).
8. Snap the mains lead (17) into the
cable hook (16).
Screwing.on.the.adjusting.
screw:
9. Press the nut (25) from the pack-
age into the recess (26) in the
grinding head (2) and screw on
the adjusting screw (6) to the
grinding head.

Operation

Working with the equipment

. Caution!.
Use only grinding disks and acces-
sories recommended by the manu-
facturer. The use of other insertion
tools and other accessories may
cause risk of injury.
Never operate the device without
the visual protection disk.
Do not use saw blades.
Check the grinding disk before use:
check the distance between the pro-
tective screen and the grinding disk.
Do not use broken, cracked or other-
wise damaged grinding disks.
Switch on the equipment only when
it is safely installed on the work sur-
face. There is a risk of injury.
Risk of injury!
Wear ear, eye and hand protec-
tion!
When working with the saw chain,
wear cut resistant gloves and an
apron if necessary, to avoid inci-
sion injuries.