Extent Of The Delivery; Operation Startup; Tensioning The Saw Chain; Chain Lubrication - FLORABEST FKS 2200 B1 Originalbetriebsanleitung

Extent of the delivery

- Chainsaw
- Chain bar (mounted)
- Saw chain (mounted)
- Saw bar protection sheath
- 180 ml Grizzly bio chain oil

Operation startup

Always wear protective gloves
when working with the chainsaw
and employ only original parts.
Pull out the power plug before
doing any work on the chainsaw
itself -– injury hazard!
The tool is completely assembled on
delivery.Before you start up the electric
chainsaw, adjust the chain, fill up with
chain oil and check the automatic lubrica-
tion and chain brake function.
Note that the saw can re-oil.
Please note that the saw re-oils after
use and oil may leak out if it is stored on
its side or on the head. This is a normal
process due to the necessary ventila-
tion opening on the upper edge of the
tank and does not constitute a reason for
complaint. As each saw is checked dur-
ing production and tested with oil, a small
residue may be in the tank despite drain-
ing, which may slightly dirty the housing
with oil in transit. Please clean the hous-
ing with a cloth.

Tensioning the saw chain

With a correctly tensioned chain you get
good cutting performance and a longer
life.
An incorrectly tensioned chain
may break or spring off, leading
to danger of injury. Test the elec-
tric saw before every start and
the chain tension after every
hour of sawing.
The chain is correctly tensioned if it does
not sag at the rail underside and can be
rotated completely around with the gloved
hand.
When the saw chain is tensioned with 9 N
(approx. 1 kg), the gap between the saw
chain and the guide rail may not be more
than 2 mm.
1. Ensure that the chain brake has
B
been released, that is, that the
chain brake lever (3) is pulled up
against the front grip (8).
2. Unscrew the fastening bolt (14).
3. To tighten the saw, turn the chain
adjustment ring (13) clockwise.
To loosen the tension, turn the
chain adjustment ring anti-clock-
wise.
4. Tighten up the fastening bolt (14)
again.
With a new saw chain, you must
readjust the chain tension after at
least 5 cutting operations.

Chain lubrication

The rail and chain must never be
without oil. If you operate the elec-
tric chainsaw with too little oil, the
GB
13