Tensioning The Saw Chain; Chain Lubrication; Filling Up With Chain Oil - FLORABEST FKS 2200 G4 Originalbetriebsanleitung

Tensioning the saw chain

Regularly tightening the saw chain pro-
or prevents wear and chain damages.
minute intervals, we recommend the user to
necessary.
The chain warms up when working with
the saw and thus expands slightly. These
"expansions" can be expected especially
Do not re-tighten or change the
chain when it is hot because it
shrinks slightly once it has cooled
this can lead to damages on the
guide rail or the engine because
now the chain is too taut on the
blade. Chain tension and chain lu-
not sag at the rail underside and can be
rotated completely around with the gloved
hand. When the saw chain is tensioned
with 9 N (approx. 1 kg), the gap between
the saw chain and the guide rail may not
be more than 2 mm.
10 min
1. Ensure that the chain brake has
B
been released, that is, that the
chain brake lever (3) is pulled up
2
(
6 .
).
3. To tension the saw chain, turn
tensioning system in clockwise
direction.
To loosen the tension, turn the
screw (9) in counter-clockwise
direction.
again (
With a new saw chain, you must
least 5 cutting operations.

Chain lubrication

The rail and chain must never be
tric chainsaw with too little oil, the
where smoke development or dis-
As soon as the motor is speeded up, the oil

Filling up with chain oil:

• Check the oil level indicator (
mum mark „MIN" (
the oil level indicator. The oil tank holds
• Use Parkside bio-oil; this product contains
additives that reduce wear and tear and
does not damage the pump system. bio-
use chain lubrication oil with low adhe-
sive additive content.
6
G B M T
).
4).
A
21)
C
-
22) is reached on
C
4 3
-