After Each Operation; Transport; Storage; Shutdown - Kärcher HD 10/16-4 Cage Bedienungsanleitung

Interrupting operation
 Release the lever on the trigger gun.
 Turn the hand wheel on the hand spray
gun to 0 to protect the lever from being
released inadvertently.
 Store the hand spray gun and spray
pipe in the accessory mount.

After each operation

After operation with detergent
 Turn the knurled nut of the detergent
nozzle in a clockwise direction until it
stops.
 Set the appliance switch to "I".
 Open the hand spray gun and rinse the
appliance for at least 1 minute.
Finish operation
 Release the lever on the trigger gun.
 Set the appliance switch to "0".
 Shut off water supply.
 Activate hand spray gun until device is
pressure less.
 Turn the hand wheel on the hand spray
gun to 0 to protect the lever from being
released inadvertently.
 Remove the water inlet hose from the
appliance.
 Pull out the mains plug.
 Stow away the mains cable, the high-
pressure hose and accessory at the ap-
pliance.

Transport

CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
 Release parking brake.
 Push the appliance.
20
Driving
Transport by crane
 Connect the lifting device in the center
of the strut to load by crane.
DANGER
Risk of injury due to dropping device.
– Check the strut for crane loading for dam-
age prior to each transport by crane.
– Only lift up the appliance by the strut
when loading by crane.
– Secure the lifting device against inad-
vertent load release.
– Remove the spray lance with the trigger
gun prior to transportation by crane.
– The appliance must only be transported
by properly trained crane personnel.
– Do stand below the load.
– Ensure that no persons are present in
the immediate vicinity of the crane.
– Do not leave the appliance on the crane
unattended.
CAUTION
Risk of personal injury or damage! Consider
the weight of the appliance when storing it.
ATTENTION
Risk of damage! Freezing water in the ap-
pliance can destroy parts of the appliance.
For longer work breaks or if a frost free stor-
age is not possible:
 Drain water.
 Flush device with anti-freeze agent.
 Screw off water supply hose and high
pressure hose.
 Operate device for max. 1 minute until
the pump and conduits are empty.
Flush device with anti-freeze agent
Note:
Observe handling instructions of the anti-
freeze agent manufacturer.
 Pump in conventional frost protection
agents through the appliance.
A certain corrosion protection is achieved
with this as well.
– 6
EN

Storage

Shutdown

Drain water