Interrupting Operation; After Each Operation; Finish Operation; Transport - Kärcher HD 10/16-4 Cage Betriebsanleitung

Nozzle change
The serial exchange nozzle is combined in
a power and a round jet nozzle.
– Here, you can switch between the pow-
er and the round jet nozzle by tilting the
spray lance slightly with the hand spray
gun closed. If necessary, if the switch-
ing does not function properly, tap light-
ly on the exchange nozzle.
– The water will emerge via the nozzle,
which has been elevated by opening
the hand spray gun.
– With the hand spray gun open, the se-
lected nozzle will always remain open,
regardless of the position of the ex-
change nozzle.
Power nozzle (two flat connection)
– 25° spray angle
– Carrying out the most common cleaning
tasks
Round jet nozzle
– For strong contaminations
Set working pressure and flow rate
Pressure/ quantity regulation at the
hand spray gun
Set the working pressure and quantity
by pulling hard on the handle on the
hand spray gun. Once the desired wa-
ter stream is reached, this handle posi-
tion can be set via the hand wheel of the
hand spray gun. Once you open it up
again, the water stream will be adjusted
automatically.
Pull the lever on the handgun.

Interrupting operation

Release the lever on the trigger gun.
Turn the hand wheel on the hand spray
gun to 0 to protect the lever from being
released inadvertently.
Store the hand spray gun and spray
pipe in the accessory mount.
18
English

After each operation

After operation with detergent
Turn the knurled nut of the detergent
nozzle in a clockwise direction until it
stops.
Set the appliance switch to "I".
Open the hand spray gun and rinse the
appliance for at least 1 minute.

Finish operation

Release the lever on the trigger gun.
Set the appliance switch to "0".
Shut off water supply.
Activate hand spray gun until device is
pressure less.
Turn the hand wheel on the hand spray
gun to 0 to protect the lever from being
released inadvertently.
Remove the water inlet hose from the
appliance.
Pull out the mains plug.
Stow away the mains cable, the high-
pressure hose and accessory at the ap-
pliance.

Transport

Driving
Release parking brake.
Push the appliance.
Transport by crane
Connect the lifting device in the center
of the strut to load by crane.
Danger
Risk of injury due to machine dropping.
– Check the strut for crane loading for
damage prior to each transport by
crane.
– Only lift up the appliance by the strut
when loading by crane.
– Protect the lifting device from inadvert-
ent load release.
– Remove the spray pipe with hand spray
gun prior to transporting by crane.