Operating instructions
Note: The ability of the heater to warm up an area is greatly dependant on the size of
the room. If the room is too large the ability of the heater to warm it up to the desired
temperature may be insufficient.
1. Plug the heater into a wall socket.
2. Turn the thermostatic control dial up to max. The heater and indicator lamp should
both come on.
3. Once the room temperature has reached the desired level, slowly turn back
the thermostat control until it clicks and the indicator lamp turns off.
4. The heater's thermostat is now set to the desired temperature and the heater will
maintain the room temperature by automatically being switched on and off.
Overheating protection
•
The overheating protection automatically trips and turns off the heater whenever it
overheats.
•
To reset the overheating protection, unplug the heater and let it cool for 15 min.
•
Then plug the heater back into a wall socket. The overheating protection should
now be reset and the heater should now work normally.
Care and maintenance
•
Clean the product using a lightly moistened cloth. Use only mild cleaning agents,
never solvents or corrosive chemicals.
•
Unplug the heater from the wall socket if it is not to be used for an extended period.
•
Store the heater in a dry and dust-free environment when it is not in use.
Troubleshooting guide
The heater does not start.
Disposal
This product should be disposed of in accordance with local regulations.
If you are unsure how to proceed, contact your local council.
Specifications
Rated voltage
230 V, 50 Hz
Power
400 W
Size
27 × 25 × 10 cm
•
Check that the mains lead is properly plugged
into an electrical socket.
•
Check that the wall socket is live.
•
The overheating protection has tripped (see
the Overheating protection section above).
6