Buttons and functions
1. Wall bracket
2. Lock screws
(one on each side)
3. Hot air exhaust port
4. Indicator light
5. Thermostat control
6. Air inlet
Assembly
Note: Remember to allow for a generous amount of
free clearance around the heater during mounting:
70 cm above
40 cm to either side
50 cm below
1. The product is intended for wall-mounted use only. Make sure that the chosen wall
mounting area is free from obstructing electrical conduit or plumbing.
2. Use the wall bracket as a drill template to
mark out the drilling holes onto the wall.
3. Screw the wall bracket to the wall.
Use suitable screws/fasteners.
4. Attach the heater to the bracket using
the included lock screws.
40 cm
5
1
2
3
4
5
6
70 cm
40 cm
50 cm