Setting Up The External Sensor; Inserting / Changing The Battery - Auriol Z30398 Bedienungsanleitung

Before Initial Use
j
D o not place the devices next to or on metal plates. Otherwise the quality of radio
wave transmission may be reduced.
Radio signal (DCF):
The DCF signal (time signal transmitter) is made up of time pulses transmitted from one of
the highest precision clocks in the world close to Frankfurt / Main in Germany - it varies by
1 second in 1 million years. In ideal conditions, your weather station can pick up this signal
over a distance of up to approx. 1,500 km around Frankfurt / Main.

Setting up the external sensor

Q

Inserting / changing the battery:

j
R emove the battery compartment cover on the back of the outdoor sensor (see Figure D).
j
I nsert two 1.5 V
note: Ensure the correct polarity. This is shown in the battery compartment
j
S et the switch
23
The outdoor sensor is now ready to operate and the control LED
j
C lose the cover of the battery compartment.
note: Select a covered location for the outdoor sensor and do not position it in the
immediate vicinity of the weather station (e.g. separated by a wall). Make sure the
outdoor sensor does not come into contact with water or direct sunlight. Electronic
devices can interfere with the radio reception.
14 GB/IE
batteries (AA) (supplied) in the battery compartment
to 1, 2 or 3 in order to select the desired outdoor sensor channel.
.
24
.
24
lights up briefly.
21