JUNO JB131D8 Benutzerinformation Seite 29

2. Lift and turn the levers on the two
hinges.
3. Close the oven door halfway to the first
opening position. Then pull forward
and remove the door from its seat.
4. Put the door on a soft cloth on a stable
surface.
5. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
2
B
6. Pull the door trim to the front to
remove it.
7. Hold the door glass panels by their top
edge and carefully pull them out one
by one. Start from the top panel. Make
sure the glass slides out of the
supports completely.
8. Clean the glass panels with water and
soap. Dry the glass panels carefully.
When the cleaning is completed, install
the glass panels and the oven door. Do
the above steps in the opposite sequence.
Make sure that you put the glass panels
(A and B) back in the correct sequence.
The first panel (A) has a decorative frame.
The screen-printing zone must face the
inner side of the door. Make sure that after
the installation the surface of the glass
panel frame (A) on the screen-printing
zones is not rough when you touch it.
29
1