Importer; Trouble Shooting; Spare Parts Order - Parkside PHD 100 D2 Betriebsanleitung

GB

Importer

Please note that the following address is
not a service address. Please initially con-
tact the service centre specified above.

Trouble shooting

Problem Possible cause
ON / OFF switch (5) is turned
off
Washer is
not opera-
Damaged power supply cable
ting
Mains fault
Air trapped in the pressure
Washer
washer
does not ge-
nerate any
Drop in the water mains
pressure
pressure
Severe
High-pressure nozzle (13) is
pressure fluc-
dirty
tuations

Spare Parts Order

Spare parts and accessories can be obtained at www.grizzly-service.eu.
If you do not have internet access, please contact the Service Centre via tel-
ephone (see "Sercice-Center" Page 37).
38
Grizzly Gartengeräte
GmbH & CO KG
Am Gewerbepark 2
64823 Groß-Umstadt
Germany
www.grizzly-service.eu
Remedy
Check ON / OFF switch
Check power supply cable (7) for
damage. If necessary have the power
supply cable (7) replaced by a quali-
fied electrician.
Check the electrical system for conformi-
ty with the data on the rating plate.
Turn on the washer with high-pressure
hose until bubble-free water flows out of
the high-pressure connection (3).
Check the water mains.
Rinse the high-pressure nozzle (13) with
water. If necessary clean the nozzle
hole with a needle.