Safety Advice Relating Specifically To This Device; Have You Understood Everything; Preparing For Use - Parkside PDS 290 A1 Montage-, Bedienungs- Und Sicherheitshinweise, Originalbetriebsanleitung, Originalbetriebsanleitung

device. Many accidents have their origins in
poorly maintained electrical power tools.
f) Use the electrical power tool, accesso-
ries, inserted tools etc. in accordance
with these instructions and advice,
and the stipulations drawn up for this
particular type of device. In doing
this, take into account the working
conditions and the task in hand. The
use of electrical power tools for purposes other
than those intended can lead to dangerous
situations.
Safety advice relating
specifically to this device
½
Securely support the workpiece. Use clamps or
a vice to grip the workpiece firmly. This is much
safer than holding it in your hand.
½
Never support yourself by placing your hands
near or in front of the device or the workpiece
surface. A slip can result in injury.
½
If a dangerous situation arises, pull the mains
plug immediately out of the mains socket.
½
Always work with the mains lead leading
away from the rear of the device.
½
DANGER OF FIRE FROM FLYING SPARKS!
Abrading metal creates flying sparks. For this
reason, always make sure that nobody is placed
in any danger and that there are no inflammable
materials near the working area.
½
WARNING!
Any harmful / noxious dusts generated from
sanding represent a risk to the health of the
person operating the device and to anyone
near the work area.
½
When sanding wood and in particular when work-
ing on materials that give rise to dusts that are
hazardous to health, the sander must be connect-
ed to a suitable external dust extraction device.
½
Ensure that there is adequate ventilation when
working on plastic, paint, varnish etc.
Downloaded from www.Manualslib.com
General safety advice for electrical power tools / Preparing for use
NOXIOUS FUMES!
Wear protective glasses and a dust
mask!
manuals search engine
½
Do not soak the materials or the surface you
are about to work on with liquids containing
solvents.
½
Do not abrade moistened materials or damp
surfaces.
½
Avoid sanding paints containing lead or other
substances hazardous to health.
½
Do not work on materials containing asbestos.
Asbestos is a known carcinogen.
½
Avoid contact with the moving sanding sheet.
½
Operate the device only with an attached
sanding sheet.
½
Never use the device for a purpose for which it
was not intended nor with non-original parts /
accessories. The use of tools or accessories other
than those recommended in the operating in-
structions could lead to you suffering an injury.
½
Switch the device off and allow it to come to a
standstill before you put it down.
½
Always keep the device clean, dry and free of
oil or grease.
©
Have you understood
everything?
½
Once you have made yourself familiar with the
instructions and advice, the functioning and
handling of your device, you are finally in a
position to start work. Observing the manufac-
turer's instructions and advice will maximise
your safety while working with the device.
©

Preparing for use

CAUTION! Make sure that the device is
switched off before you connect it to the mains
supply.
Note: Always switch on the delta sander before
bringing it into contact with the workpiece material.
Switching on the device:
Move the ON / OFF switch
setting "I".
forwards into
1
GB/IE 9