Intended Use - VOLTCRAFT ST-100 Bedienungsanleitung

3. Intended Use
- Measuring and displaying electric parameters in the range of measurement category CAT III
(up to 600 V against earth potential, pursuant to EN 61010-1) and all lower categories. Never
use it in CAT IV (at a source of low-voltage installations).
- Measurement of direct and alternating voltage up to 600 V
- Measurement resistance values of up to 20 MOhm
- Continuity test (<150 Ohm acoustic)
- Diode test
- Measuring of the satellite reception level at LNBs with 13 - 18 V/DC level switching to set
satellite systems.
The device must only be operated with the specified battery type.
The measuring device must not be operated when it is open, i.e. with an open battery compart-
ment or when the battery compartment cover is missing. Measuring in damp rooms or under
unfavourable ambient conditions is not permitted.
Unfavourable ambient conditions are:
- Wetness or high air humidity,
- Dust and flammable gases, vapours or solvents,
- Thunderstorms or similar conditions such as strong electrostatic fields, etc.
Any use other than that described above damages the product. Moreover, this is linked to dan-
gers such as short circuit, fire, electric shock, etc. No part of the product must be modified or
converted!
Always observe the safety information!
27