Description Of Individual Parts; Display Information - VOLTCRAFT ST-100 Bedienungsanleitung

4. Description of Individual Parts
See fold-out page
Components of the multimeter
1 Dial switch for setting the measuring functions
2 Display (LCD) with function and measuring unit display
3 The MODE button to switch the measuring functions
4 COM measuring jack (reference potential, minus pole)
5 V/Ω-measuring socket (plus pole)
6 HOLD button for recording the displayed measured value
7 MAX button for automatic recording the peak value
8 Rubber protection frame with rear setup bracket and battery compartment.
Components of the sat finder
9 Level display (0 – 10)
10 F socket for connection cables from the receiver unit (LNB)
11 F socket for connection cables from sat receiver/distributor
12 Dampening controller for satellite signal
13 Safety measuring lines with pluggable CAT III cover caps
Display Information
V/AC
V/DC
V
mV
mA
µA
Ω
kΩ
MΩ
HOLD
AUTO
MAX
LNB
REC
dB
28
Alternating voltage
Direct voltage
Volt (unit of electric voltage)
Millivolt (exp.-3)
Milliampere (unit of electrical current, exp.-3)
Microampere (exp.-6)
Ohm (unit of electric resistance)
Kilo Ohm (exp.3)
Mega Ohm (exp.6)
Measured is recorded
Auto-Range = automatic measuring range selection
Display of the top value
Symbol for the diode test
Symbol for the acoustic continuity tester
Input socket for the receiver cable (LNB)
Output socket for sat receiver
Symbol for signal dampening
Battery change display