Special Functions - VOLTCRAFT ST-100 Bedienungsanleitung

a) Special Functions
The multimeter has special functions that can be used individually during measurements.
HOLD Function
The HOLD function keeps the currently indicated measured value in the displays to allow you
to read or record it easily.
To switch on the HOLD function, push the "HOLD" button (6); a signal sound confirms this com-
mand and "HOLD" appears on the display.
Push the button "HOLD" (6) again or operate the dial switch (1) to deactivate "HOLD".
MAX Function
The MAX function keeps the peak value in the displays to allow you to read or record it easily.
To switch on the MAX function, push the "MAX" button (7); a signal sound confirms this com-
mand and "MAX" appears on the display.
Push the button "MAX" (7) again or operate the dial switch (1) to deactivate "MAX".
This function is not available in the measuring range diode test and continuity test.
Automatic Power-Off
In the DMM, automatic deactivation is active at all times to protect the batteries if the device is
not used for an extended period. If no button on the meter is pushed or the dial switch moved
for about 15 minutes, the DMM signals that it will soon switch off by issuing a signal sound.
Push any button or turn the dial switch to reactivate the DMM. If nothing is done, the DMM will
switch off.
After deactivation, operate the dial switch to activate the DMM again.
34