Accessories; Preparations; Installation; Installation Site - AEG MTH 350 Bedienungs Und Installationsanleitung Handbuch

8.2 Accessories

Special aerator "SR"*
◦ SR 3: Part number 289591
for MTH 350 and MTH 440
◦ SR 5: Part number 270582
for MTH 570
* For use in thread M22/M24.
Non-pressurised taps
◦ AHo 40 MTH - non-pressurised wall mounted tap
◦ AHu 40 MTH - non-pressurised twin lever basin tap
◦ AHEu 40 MTH - non-pressurised mono lever basin
tap

9. Preparations

» Flush the water line thoroughly.
Water installation
A safety valve is not required.
Taps
» Use suitable taps (see chapter "Appliance descrip-
tion / Accessories").
Note
Fitting the special aerator supplied provides an op-
timum water jet.
Installation - for contractors

10. Installation

10.1 Installation site

Install the appliance in a room free from the risk of frost
and near the draw-off tap.
Ensure that the lateral fixing screws for the cover are
always accessible.
The appliance is suitable for undersink installation (water
connections at the top) and oversink installation (water
connections at the bottom).
DANGER Electrocution
Protection rating IP25 is only ensured if the appli-
ance back panel is fitted.
» Always fit the appliance back panel.
31