Installation; Safety; General Safety Instructions; Instructions, Standards And Regulations - AEG MTE 350 Bedienungs Und Installationsanleitung Handbuch

INSTALLATION

7. Safety

Only a qualified contractor should carry out installation,
commissioning, maintenance and repair of the appliance.
7.1

General safety instructions

We guarantee trouble-free function and operational relia-
bility only if original accessories and spare parts intended
for the appliance are used.
Material losses
!
Observe the max. permissible inlet temperature.
Higher temperatures may damage the appliance. You
can limit the inlet temperature by means of a central
thermostatic valve.
7.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regula-
tions and instructions.
The specific electrical resistance of the water must not fall
below that stated on the type plate. In a linked water net-
work, factor in the lowest electrical resistance of the water
(see chapter "Specification / Data table"). Your water sup-
ply utility will advise you of the specific electrical water
resistance or conductivity.
Installation - for contractors

8. Appliance description

8.1

Standard delivery

The following are delivered with the appliance:
◦ Sieve inside the cold water inlet
◦ Special aerator "SR"
◦ Connection hose 3/8, 500 mm long, with gaskets*
◦ Tee 3/8*
◦ Company logo for oversink installation
◦ *for the connection as pressure-tested appliance

8.2 Accessories

Special aerator "SR"*
◦ SR 3: Part number 289591
for MTE 350 and MTE 440
◦ SR 5: Part number 270582
for MTE 570 and MTE 650
* For use in thread M22/M24.
Non-pressurised taps
◦ AHS 50
◦ AHo 40 MTH
installation
◦ AHu 40 MTH
◦ AHEu 40 MTH
Pressure-tested tap
◦ ADS 40
Sensor tap for washbasins
Wall mounted tap for oversink
Twin lever basin tap
Mono lever basin tap
Sensor tap for washbasins
33