Special Accessories - AEG DDLE LCD 18 Gebrauchs- Und Montageanweisung

For contractors
8.

Special accessories

• Direct tap instantaneous water heaters
ADEo 70 WD - mono-lever mixer tap with changeover bath/hand shower
Part no. 18 39 34
• Installation accessories
Pipe assembly undersink installation UT 104
Part no. 18 44 21
Water connections with 12 mm compression fittings
• Universal mounting frame
Part no. 22 77 01
Comprising:
– Mounting frame with
– electrical wiring.
This assembly creates a gap of 30 mm between the device back panel and the installation wall.
This enables the electrical connection to be routed over unfinished walls at any point behind the
equipment. This increases the equipment depth by 30 mm. This set reduces the protection to IP 24 (splash-
proof).
• Offset installation set for unfinished walls
Part no. 22 77 02
Comprising:
– Universal mounting frame (for specification see part no. 22 77 01).
– Pipe bends for a vertical offset of the device relative to the water connection by 90 mm downwards.
• Pipe assembly, replacement of a gas fired water heater
Part no. 22 77 03
Comprising:
– Universal mounting frame (for specification see part no. 22 77 01)
- Pipe bends for the installation with existing gas water heater connections (cold water on the left and
DHW on the right).
• Automatic maximum demand controller LR 1-A
Part no. 00 17 86
Priority control of the instantaneous water heater when operating, for example, electric storage heaters
simultaneously. For connection of the LR 1-A, see
34
L .