Appliance Description; Accessories; Preparations; Installation - AEG MTE 350 Bedienung Und Installation

The specific electrical resistance of the water must not fall
below that stated on the type plate. In a linked water net-
work, factor in the lowest electrical resistance of the water
(see chapter "Specification / Data table"). Your water sup-
ply utility will advise you of the specific electrical water
resistance or conductivity.
8.

Appliance description

8.1 Standard delivery
The following are delivered with the appliance:
◦ Sieve inside the cold water inlet
◦ Special aerator
◦ Connection hose 3/8, 500 mm long, with gaskets*
◦ Tee 3/8*
◦ Company logo for oversink installation
◦ *for the connection as pressure-tested appliance

8.2 Accessories

Special aerator
◦ for MTE 350 and MTE 440
◦ for MTE 570 and MTE 650
Note
Fitting the special aerator supplied provides an op-
timum water jet.
Non-pressurised taps
◦ AHo 40 MTH

installation

Wall mounted tap for oversink
◦ AHu 40 MTH
◦ AHEu 40 MTH
9.

Preparations

» Flush the water line thoroughly.
Water installation
A safety valve is not required.
Taps
» Use suitable taps (see chapter "Appliance descrip-
tion / Accessories").
10. Installation

10.1 Installation site

Install the appliance in a room free from the risk of frost
and near the draw-off tap.
Ensure that the lateral fixing screws for the cover are
always accessible.
The appliance is suitable for undersink installation (water
connections at the top) and oversink installation (water
connections at the bottom).
DANGER Electrocution
The adjusting screw for setting the flow rate is 'live',
and the IP25 protection is only given when the appli-
ance back panel is fitted.
» Always fit the appliance back panel.
Installation
Twin lever basin tap
Mono lever basin tap
33