Installation; Safety; General Safety Instructions; Instructions, Standards And Regulations - AEG MTD 350 Anleitung

Installation - for contractors

INSTALLATION

7. Safety

Only a qualified contractor should carry out installation,
commissioning, maintenance and repair of the appliance.
7.1

General safety instructions

We guarantee trouble-free function and operational relia-
bility only if original accessories and spare parts intended
for the appliance are used.
Material losses
!
Observe the max. permissible inlet temperature.
Higher temperatures may damage the appliance. You
can limit the inlet temperature by means of a central
thermostatic valve.
7.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regula-
tions and instructions.
The specific electrical resistance of the water must not fall
below that stated on the type plate. In a linked water net-
work, factor in the lowest electrical resistance of the water
(see chapter "Specification / Data table"). Your water sup-
ply utility will advise you of the specific electrical water
resistance or conductivity.
30

8. Appliance description

8.1

Standard delivery

The following are delivered with the appliance:
º Sieve inside the cold water inlet
º Special aerator "SR"
º Connection hose 3/8, 500 mm long, with gaskets*
º Tee 3/8*
*for the connection as pressure-tested appliance

8.2 Accessories

Special aerator "SR"*
º SR 3: Part number 289591
for MTD 350 and MTD 440
º SR 5: Part number 270582
for MTD 570 and MTD 650
* For use in thread M22/M24.
Pressure-tested tap
º ADS 40 Sensor tap for washbasins
Non-pressurised taps
º AHS 50 Sensor tap for washbasins
º AHu 40 MTH Twin lever basin tap
º AHEu 40 MTH Mono lever basin tap