Communication Port - PeakTech 1240 Bedienungsanleitung

Measurement
Communication
port
* Single channel is when only one input channel is working.
37.1. Trigger:
Performance Characteristics
Trigger level range
Trigger level
Accuracy (typical)
Trigger displacement
Trigger Holdoff range
50% level setting
(typical)
Edge trigger
Pulse trigger
Video Trigger
Slope Trigger
Alternate Trigger
Cursor
Automatic
Waveform Math
Waveform storage
Bandwidth
Lissajous
Phase
figure
difference
Frequency ( typical)
USB 2.0, for file storage, VGA port; LAN-interface
Internal
EXT
EXT/5
Internal
EXT
EXT/5
According to Record length and time base
100 ns~10 s
Input signal frequency ≥50 Hz
slope
Sensitivity
Trigger condition
Pulse Width range
Modulation
Line number range
Trigger condition
Time setting
Trigger on CH1
Trigger on CH2
V and T between cursors
Vpp, Vmax, Vmin, Vtop, Vbase, Vamp, Vavg, Vrms,
Overshoot, Preshoot, Freq, Period, Rise Time, Fall
Time, Delay A→B
+Duty, -Duty
＋, －, *, / ,FFT
15 waveforms
Full bandwidth
±3 degrees
1 kHz square wave
Instruction
±6 div from the screen center
±600 mV
±3 V
±0.3 div
±(40 mV + 6 % of Set Value)
±(200 mV +6 % of Set Value)
Rising, Falling
0.3div
Positive pulse : >, <, =
negative pulse : >, <, =
24 ns~10 s
Support standard NTSC, PAL and SECAM broadcast
systems
1-525 (NTSC) and 1-625 (PAL/SECAM)
Positive pulse : >, <, =
negative pulse : >, <, =
24ns~10s
Edge, Pulse, Video, Slope
Edge, Pulse, Video, Slope
-170-
, DelayA→B , +Width, -Width,