How To Use Executive Buttons - PeakTech 1240 Bedienungsanleitung

34. How to Use Executive Buttons

Executive Buttons include Autoset, Run/Stop, Single, Copy.
34.1. Autoset
This button is used for the automatic setting of all control values of the instrument to generate the waveform
suitable for observation. Press the Autoset button and the oscilloscope will perform the fast automatic
measurement of the signal.
The function items of Autoset are shown as the following table:
Function Items
Acquisition Mode
Vertical Coupling
Vertical Scale
Bandwidth
Horizontal Level
Horizontal Sale
Trigger Type
Trigger Source
Trigger Coupling
Trigger Slope
Trigger Level
Trigger Mode
Display Format
34.2. Run/Stop
Enable or disable the waveform sampling.
Notice: Under the Stop state, the vertical division and the horizontal time base of the waveform can be
adjusted within a certain range, in other words, the signal can be expanded in the horizontal or
vertical direction. When the horizontal time base equal to or is less than 50ms, the horizontal time
base can be expanded for 4 divisions downwards.
34.3. Single
Press this button you can set the trigger mode as single directly, so when trigger occurs, acquire one
waveform then stop.
Setting
Current
DC
Adjust to the proper division.
Full
Middle
Adjust to the proper division
Current
Show the minimum number of channels.
Current
Current
Mid-point Setting
Auto
YT
-158-