Assembly Instructions With Exploded Diagrams - Christopeit AX1 Montageanleitung

Assembly Instructions
Remove all the separate parts from the packaging, lay them on the
floor and check that all are there on the basis of the assembly steps in
these instructions for assembly and use. Please note that a number
of parts have been connected directly to the main frame and preas-
sembled.In addition, there are several other individual parts that have
been attached to separate units. This will make it easier and quicker
for you to assemble the equipment.
Step 1:
Attach the stabilizer (10+21) at main frame (44).
1. Attach the front foot (10) with the preassembled transport rollers (6) to
the main frame. Do this with the two screws (22), washers (7), spring
washers (19) and cap nuts (18).
2. Attach the rear foot (21) with eccentric caps (20) to the main frame.
Do this with the two screws (22), washers (7), spring washers (19) and
cap nuts (18). After assembly has been completed, you can compensate
for minor irregularities in the floor by turning the eccentric cap (20).
The equipment should be set up that the equipment does not
move of its own accord during a training session.
Step 2:
Attach the pedal (11L+11R) at pedal crank (41).
1. Screw the right pedal (11R) into the locator in the right-hand side
(as seen in operation) for the pedal crank (41) (warning! the screw
direction is clockwise).
2. Screw the left pedal (41) into the locator in the left-hand side
(as seen in operation) for the pedal crank (41)
(Warning! the screw direction is anti-clockwise).
3. Then mount the pedal straps left and right on the associated pedals
(11). (The pedals are signed with "L" for Left and "R" for Right.)
15