Assembly Instructions With Exploded Diagrams - Christopeit AF1 Montageanleitung

Assembly Instructions
Remove all the separate parts from the packaging, lay them on the floor
and check roughly that all are there on the base of the assembly steps.
Please note that a number of parts have been connected directly to
the main frame and preassembled. In addition, there are several other
individual parts that have been attached to separate units. This will
make it easier and quicker for you to assemble the equipment.
Step 1:
Attach the front stabilizer (2) at main frame (1).
1. Attach the front foot (2) with preassembled transport rollers (97) to the
main frame (1). Do this with the two screws M8x25 (4), curved washers
8//22 (6) and spring washers (5).
Step 2:
Attach the rear stabilizer (7) at main frame (1).
1. Attach the rear foot (7) with height adjustable foot screws (8) to the main
frame (1). Do this with the 4 screws M8x25 (4), curved washers 8//22
(6) and spring washers (5).
After assembly has been completed, you can compensate for minor
irregularities in the floor by turning the adjustable foot screws (8).
The equipment should be set up that the equipment does not move of
its own accord during a training session.
16