Assembly Instructions With Exploded Diagrams - Christopeit AC5 Montageanleitung

Assembly Instructions
Remove all the separate parts from the packaging, lay them on the floor
and check roughly that all are there on the base of the assembly steps.
Please note that a number of parts have been connected directly to
the main frame and preassembled. In addition, there are several other
individual parts that have been attached to separate units. This will
make it easier and quicker for you to assemble the equipment.
Step 1:
Attach the stabilizer (2+3) at main frame (1).
1. Attach the front foot (2) with the preassembled transport rollers (4) to the
main frame (1). Do this with the two screws M8x75 (7), curved washers
8//20 (8) and spring washers (9).
Attention: Mount the front foot into right direction, so that the transport
rollers don't touch the floor during exercising.
2. Attach the rear foot (3) with height adjustable foot caps (5) to the main
frame (1). Do this with the two screws M8x75 (7), curved washers 8//20
(8) and spring washers (9). After assembly has been completed, you can
compensate for minor irregularities in the floor by turning the wheel at
cap (5). The equipment should be set up that the equipment does not
move of its own accord during a training session.
Step 2:
Attach the support (17) at the main frame (1).
1. Place screws (13), each washers (9) and spring washers (8) accessibly
beside the front part of the main frame (1).
2. Place the lower end of the support (17) against the main frame (1) and
push the handlebar cover (14) onto the support (17). Plug the ends of
the two computer cable harnesses (12) and (15) projecting from (1) and
(17) together.
(Note: The computer cable harness (15) projecting from the support (17)
must not slide into the tube, as it is required for later steps of installation.)
3. Connect the middle section tension cable (16) to the bracket of lower
section cable tension (11) (See figure A1-A4]). Before this step of the
installation, it is advisable to adjust the resistance setting to the position,
at which the cable extends furthest from the sheath. Put the lowest part
of cable (16) into the small hook of lower tension cable (11) (figure A1).
Pull it (figure A2) until the small hook get in higher position (figure A3)
and then insert the cable (16) onto the bracket (11) (figure A4). When
joining the tubes, ensure that the cable connection is not trapped.
4. Put one spring washer (8) and one washer (9) on each screw (13). Push
the screws (13) through the holes in the support (17), screw into the
threaded holes of the main frame (1) but don't tighten them firmly. (This
screw connection point will screw tightly at least in Step 4)
15