Advanced Sound Configurations; Changing Sound Field Parameter Settings - Yamaha RX-V863 Bedienungsanleitung

ADVANCED SOUND CONFIGURATIONS

Changing sound field parameter
settings
You can enjoy good quality sound with the initial factory
settings. Although you do not have to change the initial
factory settings, you can change some of the parameters to
better suit the input source or your listening room.
Note
You cannot change the sound field parameter values when
"MEMORY GUARD" in "OPTION MENU" is set to "ON" (see
page 90). If you want to change the sound field parameter values,
set "MEMORY GUARD" to "OFF".
1
Turn on the video monitor connected to this
unit.
Set the operation mode selector to F AMP
2
and then press R PARAMETER on the
remote control.
The following screen is shown in the OSD.
Sound field program category
MOVIE
Cursor .
SUR.;;PLIIx Movie
DSP LEVEL;;;;;0dB
P.INIT.DLY;;;16ms
P.ROOM SIZE;;;1.0
S.INIT.DLY;;;16ms
S.ROOM SIZE;;;1.0
[p]/[[]:
Sound field parameters Sound field parameter
64
En
Advanced sound configurations
1/2
Sci-Fi
Select
values
3
Press one of the sound field program
selector buttons ( O ) repeatedly to select the
desired sound field program you want to
adjust.
4
Press 9 k / n to select the desired sound
field parameter and then 9 l / h to change
the selected sound field parameter value.
• Press 9 h to increase the value.
• Press 9 l to decrease the value.
y
• For details about the function and control range of each sound
field parameter, see page 66.
• When you set a sound field parameter to a value other than the
initial factory settings, an asterisk mark (*) appears by the
sound field parameter name in the OSD.
• Repeat steps 3 and 4 as necessary to change other sound field
program parameter settings.
• The available sound field parameters for some of the sound field
programs may be displayed on more than one page in the OSD.
In this case, press 9 k / n to scroll through pages.
• If you press and hold 9 l / h to change the sound field
parameter value, the initial factory settings are shown
momentarily in the front panel display.
• To initialize the parameters of the selected sound field program,
press 9 n repeatedly to select "INITIALIZE" and then press
9 h. Once the confirmation screen appears in the OSD, press
9 h to confirm or 9 l to cancel the initialization.
MOVIE
SB INIT.DLY;;15ms
SB ROOM SIZE ;;1.0
DIALOG LIFT;;;;;0
.
INITIALIZE
Initialize
[[]:
Press R PARAMETER to turn off the sound
5
field parameter screen.
2/2
Sci-Fi