Creating Your Original Scene Templates - Yamaha RX-V863 Bedienungsanleitung

Selecting the SCENE templates
Creating your original SCENE
templates
You can create your original SCENE templates for each
SCENE button. You can refer to the preset 17 SCENE
templates to create the original SCENE templates.
Select the desired SCENE
template
SCENE template library
(Image)
1
Turn on the video monitor connected to this
unit.
Press and hold the desired 4 SCENE button
2
for 3 seconds.
The SCENE template customizing screen appears on
the video monitor.
SCENE1
.p DVD Movie Viewing
INPUT:
MODE:
[ENTER]:Rename
[SCENE1]:SET
[RETURN]:EXIT
Note
When the SCENE template you want to customize is not
assigned to any of the 4 SCENE buttons, press 9 l / h
repeatedly to recall the desired SCENE template on the
menu screen.
40
En
Create an original SCENE
template
1
Assign the SCENE
template to the
SCENE button
[
DVD
Sci-Fi
3
Press 9 k / n to select the desired parameter
of the SCENE template and then 9 l / h to
select the desired value of the selected
parameter.
You can adjust the following parameters for a SCENE
template:
• INPUT: The input source component.
• MODE: The active sound field programs,
"Straight" or "Pure Direct" mode.
Press the 4 SCENE button again to confirm
4
the edit.
y
An asterisk mark (*) appears by the name of the original SCENE
template.
Notes
• Once the desired SCENE templates are assigned to the
corresponding 4 SCENE buttons, you need to set the input
source of the SCENE template on the remote control. See
page 41 for details.
• You can create a customized SCENE template for each SCENE
button, and if you create another customized SCENE template,
this unit overwrites the old customized SCENE template with
the new one.
• The newly created template is only available for the assigned
SCENE button.
■ Rename the SCENE templates
Select the name of the SCENE template at step 3
of "Creating your original SCENE templates" and
then press 9 ENTER.
SCENE1
RENAME
-
DVD Movie Viewing
[ ]/[ ]:Character
[p]/[[]:Position
[ENTER]:SET
[RETURN]:CANCEL
• Press 9 k / n to select the desired character.
• Press 9 l / h to place an "_" (underscore) under the
space or the desired character.
• Press 0 RETURN to cancel the new name.
• Press 9 ENTER to confirm the new name.