Bringing Into Use; Setting The Time; Operation; Using The Time Display - Silvercrest Z31281 Montagehinweise Und Bedienungshinweise Und Sicherheitshinweise

Installation / Bringing into use / Operation
the housing by sliding it downwards (Fig. A).
2. Mount the wall bracket
desired position on the wall with the sup-
plied screws
7
Note: The supplied dowels are intended for
use in ordinary solid masonry. Seek expert
advice on suitable fixings if the device is to
be fixed to another type of wall construction.
3. Pull the separation strip out of the battery
compartment
8
4. Then mount the scale on to the wall bracket
Note: Measuring accuracy may be detri-
mentally affected if the device is not in-
stalled vertically.

Bringing into use

Q

Setting the time

Q
Press the MODE / + button
j
device enters the clock mode.
Press the SET / WEIGHT MODE button
j
to enter the settings mode. The minute dis-
play value flashes.
You can use the MODE / + button
j
Digital timer / UNIT / Alarm / - button
to set the value.
Note: If you keep these buttons
pressed, you can accelerate the process
and reach the desired value more quickly.
Press the SET / WEIGHT MODE button
j
to store the set value and move on to setting
the hour display value. The hour value flashes.
You can use the MODE / + button
j
Digital timer / UNIT / Alarm / - button
set the value.
Press the SET / WEIGHT MODE button
j
to store the set value and leave the settings
mode.
Note: If no key is pressed within 10 seconds,
the set value will stop flashing and the time
is set to the value shown in the display.
8 GB/IE
75609 CB3_GB_DK.indd 8
vertically in the
10
and dowels .
6
.
10
until the
5
3
or the
5
4
,
4 5
3
or the
5
4
3

Operation

Q
The device has five functions:
1. Time display
2. Weighing
3. Temperature display
4. Alarm function
5. Digital countdown timer
. j You can switch between the various func-
tions by pressing the MODE / + button

Using the time display

Q
Press the MODE / + button
j
vice enters the clock mode.
The display shows the time (hours:minutes).
j
If you wish to change the time to another
j
value, proceed as described in the section
"Setting the time".
Note: The device continues to show the
time unless the device is switched to anoth-
er function by you pressing the MODE /
+ button
.
5

Using the scale

Q
Note: When using this product as a tabletop
unit, make sure it is placed on a solid and flat
surface for the weighing process.
Fold down the glass plate
j
to Place the weighing bowl
j
weighing platform.
If necessary press the MODE / + button
j
until the device enters the weighing
5
mode. This comes after the time display.
You can press the SET / WEIGHT MODE
j
button to switch between the weighing
3
mode settings for weight
milk . The selected weighing mode set-
15
ting is indicated by a small bar indicator in
the display.
.
5
until the de-
5
.
9
on the device's
1
, water and
17 16
7/5/2012 8:47:30 AM