Using The Digital Timer; Resetting The Settings; Replacing The Batteries - Silvercrest Z31281 Montagehinweise Und Bedienungshinweise Und Sicherheitshinweise

Operation
Press the Digital timer / UNIT / Alarm / -
j
button to start the alarm function. The
4
Alarm symbol
18
You can switch off the alarm function by
j
pressing the Digital timer / UNIT / Alarm / -
button again. The Alarm symbol
4
disappears from the display.
When the set alarm time is reached, an
j
audible alarm signal sounds for about one
minute.
j No audible alarm signal sounds if the set
time is reached when the device is in the
weighing mode. Instead the Alarm symbol
flashes in the display.
Note: If no button is pressed within a period
of two minutes, the kitchen scale's display
automatically shows the time.

Using the digital timer

Q
Press the MODE / + button
j
device enters the digital timer mode. This
comes after the alarm function.
Press the SET / WEIGHT MODE button
j
to enter the settings mode. The seconds
display value flashes.
You can use the MODE / + button
j
Digital timer / UNIT / Alarm / - button
set the value.
Press the SET / WEIGHT MODE button
j
to store the set value and move on to setting
the minute display value. The minute display
value flashes.
You can use the MODE / + button
j
Digital timer / UNIT / Alarm / - button
set the value.
Press the SET / WEIGHT MODE button
j
to store the set value and leave the settings
mode.
Press the Digital timer / UNIT / Alarm /
j
- button
to start the digital timer. The digital
4
timer indicator
Note: While the digital timer continues to
run, you can switch the device to another
function by pressing the MODE / + button
10 GB/IE
75609 CB3_GB_DK.indd 10
appears in the display.
18
until the
5
or the
5
4
or the
5
4
appears in the display.
21
The digital timer indicator
to appear in the display.
You can switch off the digital timer by press-
j
ing the Digital timer / UNIT / Alarm /
- button
again. The digital timer indicator
4
disappears from the display.
21
j When the set time expires, an audible alarm
signal sounds for about one minute and the
previously set time appears on the display.
No audible alarm signal sounds if the set
j
time is reached when the device is in the
weighing mode. Instead the digital timer
indicator flashes in the display.
18 21
Note: If no button is pressed within a period
of two minutes, the kitchen scale's display
automatically shows the time.

Resetting the settings

Q
j The reset button
back of the housing. Press this button to reset
all the settings to the default factory settings.
3

Replacing the batteries

Q
j When the batteries become weaker, the
to battery charge state indicator
display will light up.
Replace the batteries as soon as the symbol
3 j
" " appears in the display. Weak or ex-
hausted batteries can affect the accuracy of
the measurement results.
Open the battery compartment
j
to back of the scale.
j Remove the discharged batteries and dispose
of them properly in accordance with the ap-
3
plicable regulations (see section "Disposal").
Insert two new batteries type CR2032,
j
3 V into the battery compartment
Make sure you fit the batteries the right way
round (polarity). The correct polarity is
shown under the battery compartment
j Then close the battery compartment
.
5
then continues
21
can be found on the
11
in the
19
on the
8
8
8
.
8
7/5/2012 8:47:33 AM
.
.