Preparing For Use; Attaching The Disc Guard Cover Using The Quick-Release Fastener; Attaching The Auxiliary Handle - Parkside PWS 230 A1 Originalbetriebsanleitung

General safety advice for electrical power tools / Preparing for use
F or the best grinding performance move the
device evenly to and fro over the workpiece
maintaining an angle of 15° to 30° (between
grinding disc and workpiece).
W hen working on inclined surfaces do
not press the device hard down on to
the workpiece. If the speed slows greatly,
use less pressure. This will allow you to work
more effectively and safely. If the device sudden-
ly stops due to it becoming retarded or trapped,
pull the mains plug from the socket immediately.
C utting: Advance the device at an
appropriate rate. Do not incline the
cutting disc.
R oughing, grinding and cutting discs
get hot during use – allow them to
cool fully before touching them.
N ever use the device for a purpose
for which it was not intended.
B efore you insert the mains plug into
the socket, always check that the de­
vice is switched off.
I f a dangerous situation arises, pull
the mains plug immediately out of the
mains socket. Ensure that the device and
the mains plug are easily accessible and can
be reached quickly in an emergency.
W hen taking a break from your
work, before carrying out any tasks
on the device itself and when you are
not using the device, always pull the
mains plug out of the mains socket.
Always keep the device clean, dry and free of
oil or grease.
R emain alert at all times! Always watch
what you are doing and proceed with
caution. Do not use the device if you cannot
concentrate or you are feeling unwell.

Preparing for use

Q
Attaching the disc guard cover
Q
using the quick­release fastener
Pull the mains plug out of the mains
30 GB/MT
DANGER OF INjURy!
socket before you carry out any task
on the device.
DANGER OF INjURy! Always use the
angle grinder with the disc guard
cover in place. The disc guard cover must
be securely attached to the angle grinder. To
ensure the highest level of safety while using
the device, ensure that the smallest possible
area of the grinding or cutting tool is exposed
to the operator at all times. The disc guard cov-
er is there to protect the operator from pieces
breaking off and accidental contact with the
grinding or cutting tool.
DANGER OF INjURy! Ensure that the
guard is attached so that its edge
7
is beyond the angle of the auxiliary
handle (see Fig. B). Otherwise you
6
could injure yourself against the grinding or
cutting disc.
O pen the clamping lever
I nsert the disc cover guide
projection in the coded groove
9
T urn the disc guard cover
position (working position). The closed side of
the disc guard cover
the operator.
C lose the clamping lever
the disc guard cover
If necessary the clamping force of the connection
can be adjusted by tightening or loosening the
adjuster screw .
10
Ensure that the disc guard cover
on the spindle collar.

Attaching the auxiliary handle

Q
CAUTION! For safety reasons this
device must always be used with the
auxiliary handle
you could become injured.
Pull the mains plug out of the mains
socket before you carry out any task
on the device.
S crew the auxiliary handle
or on the top of the head of the device.
.
8
with the coded
7
.
16
into the desired
7
must always be facing
7
to firmly clamp
8
in place.
7
sits firmly
7
in place. Otherwise
6
DANGER OF INjURy!
on the left, right
6