Proper Use; Features And Equipment; Included Items; Technical Information - Parkside PWS 230 A1 Originalbetriebsanleitung

Introduction
Angle grinder PWS 230 A1
Introduction
Q
We congratulate you on the purchase of your new
device. You have chosen a high quality product. The
instructions for use are part of the product. They
contain important information concerning safety,
use and disposal. Before using the product, please
familiarise yourself with all of the safety information
and instructions for use. Only use the unit as descri-
bed and for the specified applications. If you pass
the product on to anyone else, please ensure that
you also pass on all the documentation with it.

Proper use

Q
This tool is suitable for cutting, roughing and brush-
ing metal materials without the use of water. Any
other use or modification to the device shall be
considered as improper use and could give rise to
considerable dangers. We will not accept liability
for loss or damage arising from improper use. The
device is not intended for commercial use.
Note: Slots cut in load-bearing walls must comply
with standard DIN 1053 Part 1 or the regulations
applicable in your country.
These instructions and advice must be observed.
Before you start a task, seek the advice of a com-
petent structural engineer, architect, or the relevant
site management staff.

Features and equipment

Q
Hand grip (rotatable)
1
ON / OFF switch
2
Safety lock-out
3
Unlocking button
4
Carbon brushes cover
5
Auxiliary handle
6
Disc guard cover
7
Clamping lever
8
Coded projection
9
Adjuster screw
10
22 GB/MT
Spindle lock button
11
Threaded hole (3 x) for auxiliary handle
12
Clamping nut (see Fig. G)
13
Mounting spindle (see Fig. G)
14
Mounting flange (see Fig. G)
15
Coded groove (see Fig. G)
16
Spanner
17
Roughing / grinding disk*
18
Cutting disc for metal* (see Fig. E)
19
Cutting disc for masonry* (see Fig. F)
20
* not included

Included items

Q
1 Angle grinder PWS 230 A1
1 Auxiliary handle
1 Disc guard cover
1 Spanner
1 Operating instructions

Technical information

Q
Rated voltage:
Rated power consumption: 2000 W
Rated speed:
Grinding disc:
Mounting spindle:
Protection class:
Noise and vibration data:
Measured values for noise are determined in accor-
dance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level:
Sound power level:
Uncertainty K:
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
h
Uncertainty K = 1.5 m / s
230–240 V ~ 50 Hz
n 6500 min -1
Ø 230 mm
M14 / threaded
II /
96.8 dB(A)
107.8 dB(A)
3 dB
= 10.075 m / s
2
2