Cleaning And Maintenance - EuroLite TMH XB-200 Bedienungsanleitung

Manual Ctr.
Manual
Exit
Lamp on timer
Reset timer
Message
Set on timer
Set password
Exit

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tightly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) Mechanically moved parts like axles, eyes and others must not show any traces of wearing (e.g. material
abrading or damages) and must not rotate with unbalances.
4) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or
solvents!
(01-16) (001-255)
XXXX:00
Code1/Code2
Code1/Code2
Code1/Code2
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
Test function of each channel
With this function you can test each channel
on its (correct) function.
Return to the main menu
Lamp time
With this function you can display the running
time of the lamp. The display shows
"XXXX:00", "X" stands for the number of
minutes, "0" stands for the number of
seconds.
Clear lamp time
With this function you can clear the running
time of the lamp. Please clear the lamp time
every time you replace the lamp.
Password factory setting „000"
Programmed running time
With this function you can set an individual
running time for the device (in minutes). The
device will automatically switch off after the
countdown ends.
Only by entering the password the device will
return to normal operation again.
Password factory setting „000"
Set new password
With this function you can set an individual
password.
Return to the main menu
36/38 00094283.DOC, Version 1.0