EuroLite TMH XB-200 Bedienungsanleitung Seite 29

followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Install the safety bond by inserting the quick link through the attachment eyelet on the bottom of the device.
Pull the safety bond over the trussing system or a safe fixation spot. Insert the end in the quick link and
tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!
Screw the clamp via a M10 screw and self-locking nut onto the Omega-holder.
Insert the quick-lock fasteners of the Omega-holder into the respective holes on the bottom of the device.
Tighten the quick-lock fasteners fully clockwise.
DANGER TO LIFE!
29/38
The Moving-Head can be placed
directly on the stage floor or rigged in
any orientation on a truss without
altering its operation characteristics
(see the drawing).
For overhead use (mounting height
>100 cm), always
appropriate safety bond.
You must only use safety bonds
complying with DIN 56927, quick links
complying with DIN 56927, shackles
complying with DIN EN 1677-1 and
BGV C1 carbines. The safety bonds,
quick links, shackles and the carbines
must be sufficiently dimensioned and
used correctly in accordance with the
latest industrial safety regulations (e.
g. BGV C1, BGI 810-3).
Please note: for overhead rigging in
public or industrial areas, a series of
safety instructions have
00094283.DOC, Version 1.0
install an
to be